Club Workshop Sunday January 20

jbcollier · Post by **jbcollier** » Wed Jan 02, 2013 7:36 pm

Hi Everyone,

We will be having a club workshop on Sunday Jan. 20, 10 a.m. at my work place (12116 - 121a St). We will be changing the crank seals on David's Lambretta.

Anything else David?

david · Post by **david** » Thu Jan 03, 2013 1:28 pm

Lets hope that is the only big job to do, as there are no other issues that I'm aware of.
I have some new bearings "just in case"; rear hub, drive side, clutch needle roller bearings, ect. Also, new clutch plates and a Jockeys top chain tensioner, and some other bits and bobs.

Angelo · Post by **Angelo** » Sat Jan 19, 2013 2:45 pm

Sorry Guys, something has come up and I can't help you with the rebuild / refresh of David's motor.

I will drop off the tools and saw horses around 9.30am, Hopefully they will help make things run more efficent.

David, I don't have a spare sliding dog. I will keep looking to see if I can locate my shim, but I'm pretty sure I only have a "standard"? stock shim. The larger one that I bought I used on lefty.

Cheers

jbcollier · Post by **jbcollier** » Sat Jan 19, 2013 2:56 pm

I should be there by 9:30 though perhaps 9:45 to be safe.

jbcollier · Post by **jbcollier** » Sat Jan 19, 2013 3:23 pm

Hi Angelo,

We'll be fine without your tools. David/Graham has a rear hub puller. I'm pretty sure I have a flywheel puller and we can improvise a clutch compressor. So don't go out of your way.

Cheers

david · Post by **david** » Sat Jan 19, 2013 4:55 pm

Thank-you for looking Angelo, sorry that you can't make it.
I guess we will only need 1/2 dozen doughnuts now

jbcollier · Post by **jbcollier** » Sat Jan 19, 2013 5:02 pm

David,

Please remind me to check the squish of your top end for Angelo.

Cheers

david · Post by **david** » Sat Jan 19, 2013 9:10 pm

Shall do John.

Graham has a clutch compressor, rear hub puller, and will bring some other tools as well.

jbcollier · Post by **jbcollier** » Sun Jan 20, 2013 3:18 pm

One step forward and two steps back. David also needs a thicker gearbox shim and a new shift cruciform. Graham came with his new (to him) tools in tow and he has all sorts of cool factory Lambretta tools. Neat. RB John caught a few things and cleaned like a champ.

Thanks!

david · Post by **david** » Sun Jan 20, 2013 10:16 pm

Graham, RB John, and John C. you guys are stars!!!

Thank-you, thank-you, thank-you, for your help, and all the laughs.

redbike · Post by **redbike** » Sun Jan 20, 2013 11:55 pm

Always a pleasure, never a chore...when are we able to finish the work?