Dale is coming up Sunday April 3, 10 am, for part two of the CCSC workshop on his Vespa engine. Hopefully we'll finish the job this time.
The workshop will be at Sports Car Centre, 12116 - 121A St. Please, please check the link below if you have never been there before. It's a bit tricky to find the first time.
http://maps.google.ca/maps?f=q&source=s ... L+0E2&z=16
Everyone's welcome!
CCSC Workshop part deu:10 am April 3
Moderator: Moderators
If all my planning and a little luck comes together, there will be no need for pictures. I could be bringing my Lammy home very soon! But not soon enough, I'm sure for my Lambretta all alone, sharing transport and accommodation with a bunch of Harleys and Yamahas We both can't wait!!! So until then, I will enjoy doughnuts, the delight of everyones company, and the pleasure of seeing Dale's Scoot come together.
Ska'D for Life
- LibertineAudrey
- Posts: 840
- Joined: Wed Mar 21, 2007 11:56 pm
- Location: Sherwood Park
- Contact:
I'm going to have to miss today too. I have another commitment today and need to get started on my reading for my University class.
Good Luck Dale, I hope that you engine get's finished today.
Shannon
Good Luck Dale, I hope that you engine get's finished today.
Shannon
"The real danger is not that machines will begin to think like men, but that men will begin to think like machines." Sydney J. Harris
Sigh, one wrong part. The kickstart gear has a bore of 22 mm and 13 teeth on the ratchet face. We need a bore of 20.5 mm and 12 teeth. Gear is on order and should be in on time to:
viewtopic.php?p=8230#8230
viewtopic.php?p=8230#8230