Removing Gasket Material

Offtopic discusion goes here

Moderator: Moderators

Post Reply
User avatar
nick
Posts: 171
Joined: Mon Dec 26, 2011 9:01 pm
Location: Edmonton

Removing Gasket Material

Post by nick »

Hey All,

Just wondering if anyone has any suggestions on how to remove stubborn gasket material from an aluminum case cover(Honda)? I've got about 98% of it off, but the last little bit is not budging.. I got a little bit using a razor and WD40 being EXTREMLY careful not to mark the sealing surface, but that only got a little more off. Is that Permatex gasket remover the way to go? Also, do you suggest treating new gaskets with anything before installing them?

I've had all my parts for a couple months now and want to actually ride. :)
Top
User avatar
jbcollier
Posts: 4112
Joined: Thu Sep 21, 2006 8:50 pm

Post by jbcollier »

I believe gasket remover works though I have never used it myself. They have special gasket removing abrasive pads for dremels and small grinders. If you're worried about the surface try the remover first.
Top
Post Reply

Return to “Offtopic”